Olicom A400A manual Setting up the router, Location environment, Connect your Wide Area Network

Page 8

Installation

1. Setting up the router

ADSL Service
Port on Wall	RJ-45 Ethernet cable

RJ-11 cable

Adapter

External Filter DB-9 to RJ-14 Console cable

The location environment

Place the router in a location where air can circulate freely around it. The router case has vents on top cover and its sides. Leave at least two (2) inches of clearance between the vents on the both sides of the router and any object that might restrict air flow. Never operate the router when its vents are covered or obstructed.

Connect your Wide Area Network

Plug one end of the phone cable in the port labeled LINE on the rear panel of router until you feel it lock and connect the other end of line to your ADSL wall jack.

Connect the CONSOLE port

The CONSOLE port lets you connect the router to a personal computer through the console cable to configure, administer and monitor your ADSL router setting with Graphic User Interface (GUI). (described in the chapter of Configuration on page 10)

6

Image 8

Contents Model A400A Adsl Router Contents Cleaning Power sourcesPower cord protection EnvironmentDamage requiring service OverloadingServicing Modem/Telephone useOverview Packing listTaking a look at the Adsl router Front ViewRear View Setting up the router Location environmentConnect your Wide Area Network Connect the Console portConnect the adapter Install a telephone filterConnect the local devices Installation of the application program of Router AP Configuring the Adsl router User Enter Your username lets the router record your accessPage Page Entering Basic Settings Quick SetupGathering Configuration Information Encapsulate Select the encapsulation setting PPPoEPage RFC 1483 bridge EoA Page Routing over RFC 1483 bridge Page RFC 2364 PPPoA Page IPoA RFC 1483 route Page Advanced Configuration LANDhcp Client Mode Page Page Œ NAT Network Address Transfer IP SharingŒ Virtual Server Range of this field is 0 to Page Page Page Routing Protocol RIP Page Version Use the dropdown menu to select the version ISP Internet Service Provider Spanning Tree Snmp Page Page ATM Interface & VCs Special Function Packet FilterPage Maintenance User ProfileSupervisor tab Monitor IF0Show Setting Fixed Host Entries No. IP Address Ethernet Address Upgrade PingReset to Default SaveReboot System InformationTroubleshooting