Olicom A400A manual

Page 12

Options are : Serial port, Network

Serial port :You can use the attached console cable to connect the router and a personal computer to configure, administer and monitor your ADSL router with Graphic User Interface (GUI).

a)Plug the RJ-14 end of console cable into the CONSOLE port on the router back panel.

b)Connect the other DB-9 end of console cable to a serial port (COM1 or COM2) of your computer.

Network: Or you can open a Network connection from a workstation on your network. You must know the IP address of the router before you can make a Network connection to it. By default , the router uses 192.168.1.1 as the IP address for its LAN interface. You can use the Graphic User Interface (GUI) to configure the router IP address.

Retry interval: Enter the timing of how many seconds you want to reconnect the router if failure. (The default is 3 seconds.)

10

Image 12

Contents Model A400A Adsl Router Contents Cleaning Power sourcesPower cord protection EnvironmentDamage requiring service OverloadingServicing Modem/Telephone useOverview Packing listTaking a look at the Adsl router Front ViewRear View Setting up the router Location environmentConnect your Wide Area Network Connect the Console portInstall a telephone filter Connect the local devicesConnect the adapter Installation of the application program of Router AP Configuring the Adsl router User Enter Your username lets the router record your accessPage Page Quick Setup Gathering Configuration InformationEntering Basic Settings Encapsulate Select the encapsulation setting PPPoEPage RFC 1483 bridge EoA Page Routing over RFC 1483 bridge Page RFC 2364 PPPoA Page IPoA RFC 1483 route Page Advanced Configuration LANDhcp Client Mode Page Page IP Sharing Œ Virtual ServerŒ NAT Network Address Transfer Range of this field is 0 to Page Page Page Routing Protocol RIP Page Version Use the dropdown menu to select the version ISP Internet Service Provider Spanning Tree Snmp Page Page ATM Interface & VCs Special Function Packet FilterPage Maintenance User ProfileSupervisor tab Monitor IF0Show Setting Fixed Host Entries No. IP Address Ethernet Address Upgrade PingReset to Default SaveReboot System InformationTroubleshooting