Omega Vehicle Security CN3271 Series manual Panel Cutout Wiring Guidelines

Page 6

PANEL CUTOUT

WIRING GUIDELINES

 

A)

Measuring Inputs

 

NOTE: Any external components (like Zener di-

 

odes, etc.) connected between sensor and input

 

terminals may cause errors in measurement due to

 

excessive and/or not balanced line resistance or

 

possible leakage currents.

 

TC

Input

 

+ 10

 

_

9

 

 

 

 

Shield

 

+ 10

Fig.3

 

 

_

9

Shield

Fig. 4 THERMOCOUPLE INPUT WIRING

NOTE:

1)Do not run input wires with power cables.

2)For TC wiring use proper compensating cable, preferably shielded (see Appendix B).

3)Shielded cable should be grounded at one end only.

3

LHL-1-NEUTRO.pmd

3

19/04/2004, 15.06

Image 6
Contents CN3271-add2.pmd 19/08/2004 OMEGAnet On-LineService Internet e-mail Info@omega.com Contents Screw Bracket Panel Mounting RequirementsDimensions and Rear Terminal Blocks Without RS-485 With RS-485Panel Cutout Wiring Guidelines MA, mV and V Inputs Wiring RTD Input Linear InputOUT 1 Class Logic Input for models with RS-485 onlyRelay Outputs Use cupper conductors onlyInductive Loads Serial Interface100 to 240 Vac Power Line and groundingAA/A 500 mA 250 100/240 V AC 125 mAHigh Low Limiter with RS-485 High Low Limiter without RS-485Configuration KEY Functions Configuration ProcedureSerial Interface Protocol Type R5 = Offset AdjustmentR7 = Alarm action on input fault Value R2 = Decimal Point PositionC2 = Rearming Mode Hi.Lo = High and low limit for special process= Alarm configuration = Rearm at Power-up Auto = Automatic rearmConstant Alarm Function = Shutdown memoryP3 = Alarm Action Example for P2 = H.A.A.cExample for P2 = H.L Alarm Standby mask Function = Safety LockT1 = Timeout Selection Operating Mode Normal Display ModeNormal Display Mode to Operative Parameter Display Mode IndicatorsFlashes when alarm is on Operative Parameter Display ModeOperating Parameters Limiter function Example 1 C1 = Hi and C2 = O Example 2 C1 = Hi and C2 =Alarm functions Serial LInk optionalDevice can be connected to a host computer via serial link Error List Error MessagesError Messages Dealing with Error MessagesCommon mode rejection ratio General SpecificationsPower consumption 8 VA Temperature Drift CJ excludedInputs Thermocouple Linear InputsOutputs AlarmLogic Inputs OutputMaintenance Serial Communication Interface OptionDefault Parameters Default Operating Parameters ListLHL-A-NEUTRO.pmd 19/04/2004 Second Seconds Appendix A.3 Appendix B Thermocouple Compensating Cable Color Codes Return Requests / Inquiries Data Acquisition