Ratoc Systems SMA03U manual

Page 39

If there is [!] or [×] mark in the Universal serial bus controller, double-click the item and follow the next instructions.

5.You will see a screen below. Click Enable Device button on the General tag screen. In this case,there is a [!] or [×] mark on USB Host Controller.

39

Image 39

Contents SMA03U System requirements SmartMedia compatibility FeaturesProgram update and support TrademarksFormat SmartMedia Troubleshooting FCC Statement Introduction About the SMA03U User Guide Name of the parts of SMA03 Restrictions System requirementsBefore using SMA03U Ratoc Systems,Inc How to registerPage For Windows98 Connect the SMA03U to the PC SetupWhen you insert USB cable to the PC for the first time Installation of the driver for Windows98 DeviceRecommended. Then click Next button Page When the following window appears,click on the Next button Page When the following window appears,click on the Next button Your deviceRecommended.Then click Next button Click on the Next button Page Page Page Page Access LED Using SMA03URemoval of SMA03U Inserting the SmartMedia Push the SmartMedia until it is firmly seated Removing the SmartMedia Pull the SmartMedia out of the slot as shown below Handling files in SmartMedia Format SmartMedia About Write-Protect of SmartMediaRemovable Disk TroubleshootingDevice Manager My ComputerSet USB Port Enable Click on the Device Manager tab Page Page Page Page Set SMA03U Enable Click on the Device Manager tab Page Page Adapter Page For Macintosh Setup for Macintosh Installation of the driver for Macintosh Page You will see a screen below. Click Restart Connect the SMA03U to the Mac Using SMA03U Removal of SMA03U Turn the gold surface Front as shown above Page Removing the SmartMedia Pull the SmartMedia out of the slot as shown below Handling SmartMedia Page Problem Cause Solution Install the driver again SMA03U Specifications