NetComm NP3024 manual Connecting Network Cable, AC Power

Page 10

Figure 2. Mount the Switch in the rack

Connecting Network Cable

The Switch supports 1000Mbps Gigabit Ethernet that runs in Auto-negotiation mode, 10Mbps Ethernet or 100Mbps Fast Ethernet that runs both in half and full duplex mode, and 1000Mbps Gigabit Ethernet that runs in full duplex mode using four pair of Category 5 Cable.

Important Note:

Some Category 5 cables are only prepared with two pairs (4 wires) of interconnection wires which are not suitable for Gigabit Ethernet over Category 5 cables.

In order to use the full performance of this switch in Gigabit mode, please ensure that your cabling uses four pairs (8 wires). The switch’s RJ-45 ports are Auto-MDI and will auto negotiate between 10Mbps, 100Mbps and 1000Mbps depending on the type of cable and connection. The Switch can auto transform to MDI-II or MDI-X, so there is no need to use cross-over cables or an up-link port.

AC Power

The Switch uses AC power 240V AC, 50 Hz. The power switch is located at the rear of the unit adjacent to the AC power connector and the system fan. The Switch may be turned on without having any or all LAN segment cables connected.

NetComm 16 or 24 port Gigabit Switch

YML711 Rev1

10

www.netcomm.com.au

Image 10
Contents Page Contents YML711 Rev1 Introduction Gigabit Ethernet TechnologySwitching Technology Vlan Virtual Local Area Network VlanFeatures Package Contents Installation Rack MountingConnecting Network Cable AC PowerIdentifying External Components Front PanelRear panel of the Switch Rear PanelPower and System LEDs Understanding LED IndicatorsPorts 1~16 or 1~24 Status LEDs 1000Mbps Installing the Web Management Utility Web Management UtilityDiscovery List Monitor List View trapTrap Information Device Setting After completing the details, type a passwordFirmware Upgrade View TAB ToolbarFile TAB Option TABConfiguring the Switch LoginLogin Main Menu Main menuSetup Menu Port SettingsVlan Settings Virtual Local Area Network Vlan Group SettingsTrunk Setting Port Vlan SettingsMaintenance Menu Mirror SettingDevice Status Statistic StatisticSystem Setting System SettingTrap Setting Trap SettingSet Password Set PasswordBackup Setting Reset SettingLogout LogoutAppendix a Technical Specifications GeneralPerformance Appendix B Cable Connections RJ-45 Ethernet Network ports1000BASE-T straight through cable 1000BASE-T crossover cable Contact Information Appendix C Registering your NetComm ProductTrade marks and Notices Legal & Regulatory Information Copyright Information Customer InformationWarranty Conditions and exclusions