NETGEAR WG511v2 user manual Setting up WEP Encryption Security

Page 39

User Manual for the NETGEAR 54 Mbps Wireless PC Card WG511v2

Setting up WEP Encryption Security

Follow the steps below to configure WEP Encryption Security.

1.Run the WG511v2 Smart Wizard.

a.Make sure the WG511v2 software is installed and the WG511v2 is fully inserted in an available CardBus slot in your laptop computer.

b.Use the icon to open the Smart Wizard. The Settings tab page opens.

Figure 4-8

2.Configure the Security settings.

a.In the Profile box, select the profile or type in a profile name.

b.In the Network Name (SSID) field select the network, or enter the SSID.

Note: You will not get a wireless network connection unless the network SSID matches exactly what is configured in the access point.

c. In the Security section, select WEP.

Network Connections and Wireless Security

4-11

v2.2, December 2005

Image 39
Contents NETGEAR, Inc Technical Support Europe EU Declaration of Conformity Vv2.2, December Product and Publication Details Vv2.2, December Contents Chapter Troubleshooting Audience, Scope, Conventions Chapter About This ManualV2.2, December About the Netgear 54 Mbps Wireless PC Card WG511v2 Key Features and Compatible ProductsChapter Introduction What’s in the Box? Road Map for How to Get There From Here Road Map for ‘How to Get There From Here’Netgear 54 Mbps Wireless A Road Map for How to Get There From Here V2.2, December Chapter Basic Setup What You Need Before You BeginVerify System Requirements WG511v2 Default Wireless Settings Observe Wireless Location and Range GuidelinesInfrastructure and Ad Hoc Modes For Windows XP Users Installing a WG511v2 Basic Installation InstructionsV2.2, December V2.2, December For Windows 2000 & 98SE/Me Users Installing a WG511v2 V2.2, December V2.2, December Smart Wizard Status Bar Connecting to Wireless Networks and the InternetConnection Indicator Description WG511v2 LEDs WG511v2 Icon ColorsUpgrading the WG511v2 Software Removing the WG511v2 SoftwareUnderstanding the WG511v2 Smart Wizard Network Connections and Wireless SecurityFinding a Network Adding Profiles ProfilesSetting up a Profile to Connect to an Access Point or Router Setting up a Computer-to-Computer Ad Hoc Profile V2.2, December V2.2, December Starting a Computer-to-Computer Ad Hoc Network Connection Using Wireless Security Features Wireless SecurityIf WEP Authentication is Used Wireless Network Name Ssid and Security SettingsSetting up WEP Encryption Security Setting up WPA2-PSK Security V2.2, December Setting up WPA-PSK Security Networks Advanced SettingsButtons Statistics About V2.2, December V2.2, December Chapter Troubleshooting Troubleshooting TipsFrequently Asked Questions WG511v2 Smart Wizard keeps asking me to save my settings WG511v2 is not getting an IP address XP Professional and XP Home occasional connection problemsVv2.2, December FCC, CE, Telec Appendix a Technical SpecificationsTechnical Specifications Document Link Appendix B Related DocumentsAppendix B-2 Related Documents
Related manuals
Manual 2 pages 53.13 Kb