NETGEAR WG111U user manual Netgear Super AG

User’s Manual for the NETGEAR Super AG Wireless USB 2.0 Adapter WG111U

Table 2-1.	A Road Map for How to Get There From Here
If I Want To?	What’s Needed?		What Do I Do?		How Do I?
Connect to the	1.	An active Internet	1.	Activate your	To configure your WG111U in
Internet over the		connection like those from		wireless link and	Infrastructure Mode, see “Basic
wireless		cable or DSL service		verify your network	Installation Instructions” on
network.		providers.		connection.	page 3-4, and locate the section
	2.	A wireless network	2.	Open an Internet	for your version of Windows.
		connected to the cable or		browser such as
		DSL Internet service		Internet Explorer	For assistance with configuring
		through a cable/DSL		or Netscape	the TCP/IP Internet software on
		router as illustrated in		Navigator.	a PC, see “Preparing Your
		“Connecting to an Access			Computers for TCP/IP
		Point in Infrastructure			Networking” on page C-4 or refer
		Mode” on page 4-2.			to the PC Networking Tutorial on
	3.	TCP/IP Internet			the NETGEAR Super AG
		networking software			Wireless USB 2.0 Adapter
		installed and configured			WG111U Resource CD and the
		on your PC according to			Help information provided in the
		the requirements of the			Windows system you are using.
		Internet service provider.			.
	4. A browser like Internet
		Explorer or Netscape
		Navigator.

2-6 Introduction

202-10065-01