
Installation Guide for the NETGEAR 54 Mbps Wireless PCI Adapter WG311
WG311 Default Wireless Configuration Settings
If this is a new wireless network installation, use the factory default settings to set up the network and verify wireless connectivity. If this is an addition to an existing wireless network, you will need to identify the wireless configuration and security parameters already defined.
Your NETGEAR 54 Mbps Wireless PCI Adapter WG311 factory default basic settings are:
•Network Name Service Set Identification (SSID): ANY — a special name which indicates the first available network will be used
Note: In order for the WG311 Wireless PCI Adapter to communicate with a wireless access point or wireless adapter, all devices must be configured with the same wireless network name (SSID).
•Network Mode (Infrastructure or
•Data security WEP encryption: Disabled
The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless PCI Adapter WG311 for basic wireless connectivity to an access point. The procedures provide
Basic Setup |