The Setup Tab
Wireless Mode: | Lets you select the network scenarios, either |
| Infrastructure. Default setting is “Infrastructure” |
Wireless Network Name (SSID): | Lets you set the Service Set Identification. Default SSID |
| is empty. When it sets to empty, the NP5410 is allowed |
| access any nearby AP or wireless devices. |
Channel: | Enables you to select a transmission channel. This |
| setting only works in |
| mode, the NP5410 will follow AP or router’s channel |
| setting. |
Transmission Rate: | Select transfer rate from an available list. |
Performance Mode: | In Maximum interoperability mode, the NP5410 will |
| connect to both 802.11b and 802.11g devices. In |
| Maximum performance mode, the NP5410 will only |
| connect to 802.11g devices for better performance. |
Click button “Save” to store the settings. The settings will work after NP5410 reboot.
Note: You may need to reboot the NP5410, and then
Rev. 1 - YML675 | www.netcomm.com.au |
NP5410 Wireless Ethernet Bridge User Guide | Page 17 |