Installing the Wireless Navigator
The Wireless Navigator Utility is provided to allow user(s) easily to configure the AP through any
1.Insert the installation
2.After the InstallShield Wizard preparation has completed finished, the Install Shield window will be shown. Click the Next button to continue.
3.Key in your User Name and Company Name, and click Next button to continue.
4.The screen will show you the default destination chosen by the utility. If you wish to install the Wireless Navigator in another location, click the Browse button and select an alternate destination. Click the Next button when you are ready to continue. The setup program will then begin to install the programs into the destination folder.
5.The screen will show you the Program Folder that the utility will use. You may type a new folder name to create a new program folder, or select one from the existing folder list, and click Next button to continue.
6.The Wireless Navigator has been installed now. Please click the Finish button to complete installation.
Note: To remove Wireless Navigator Utility, click the Start button, and select Programs, Wireless Navigator, and Uninstall, and then follow the instruction on screen.
Rev. 1 - YML668 | www.netcomm.com.au |
NP5400 11g Wireless Access Point User Guide | Page 13 |