NetComm NP725 manual WDS List Status

Page 49

Chapter 4. Web Management Interface

4.5.3 WDS List Status

The list shows the WDS link status with information such as Link Status, MAC Address, SNR(dB), Tx Rate, Tx Count, and Tx Errors.

Link Status: Show Link Status such as Disconnected, Disabled or Connected.

MAC Address: MAC Address of the WDS peer

SNR: Single to Noise Ratio

Tx Rate: Transmit rate

Tx Count: The number of Transmit Count

Tx Errors: The number of Transmit Errors

46

Image 49

Contents User Guide Table of Contents Legal & Regulatory Information Overview Product FeaturesDeployment Topology Examples System Overview Rear Panel ƒ Reset ButtonLED Top PanelInstallation Basic Configuration Change Password Check VAP Profile Settings Configure AP SettingsChoose Security Type Check AP StatusInstallation Installation Installation Installation Configure the Peer Configure WDS SettingsObtain WDS List Status Congratulations Web Management Interface Introduction Log into Web Management Interface System Information SystemWeb Management Interface Web Management Interface Network Settings Management Services Virtual AP Overview Web Management Interface Web Management Interface Mode Channel Rate General SettingsPower VAP Configuration Security Settings Web Management Interface Web Management Interface Advanced Wireless Settings ƒ Allow List Access Control Settingsƒ Radius ACL Web Management Interface WDS Link Overview WDSWDS Link Settings Utilities Change PasswordConfiguration Save / Restore System Upgrade Reboot System Overview StatusDescription Associated Client Status WDS List Status Event Log Online Help 7Legal & Regulatory Information Customer InformationGNU General Public License Limitations of Warranty Product Warranty Technical Support