Chapter 3. Installation
Chapter 3. Installation
3.1Wireless LAN Access Point Connection
Please follow the steps below to install the hardware of NP725.
1.Locate the wireless LAN access point at the best location. The best location for NP725 is usually at the center of a wireless network.
2.Connect the wireless LAN access point to your other network equipment.
Connect an Ethernet cable to the NP725’s LAN port and connect the other end of the cable to a switch, a router, or a hub. The access point will be connected to your existing wired LAN network.
3.There are two options to supply power to NP725.
1)Connect the DC power adapter to the power socket. Please note that using a different adapter may damage the product.
2)Connect a PoE capable device (switch or PSE) to the LAN port.
Now, the Hardware Installation has been completed.
Note:
1.Please refer to LEDs of the switch/hub to verify the wired connection of both sides.
2.Dual LAN ports can be used for power failover, but there could be a problem with dual data links in the same LAN environment, unless appropriate Layer 2 STP configuration has been made for the entire network. Please refer to 4.1.2 Network Settings (Layer 2 STP) for more information.
6