| 4xN 10/100/1000 Span iMatrix Switch |
DB9 Control Port 2 |
|
CONTROL PORT 1 CONTROL PORT 2 | 1 2 3 4 5 6 7 8 |
| OFF |
To COM port on monitoring device or computer
Figure 9: Connecting to the CLI
3.Launch your terminal emulation software and set the communication parameters to:
19200 baud
8 data bits No parity 1 stop bit
No flow control
3.Connect power to the iMatrix Switch. The CLI banner and login prompt appears.
*************************************
* Net Optics Command Line Interface *
*************************************
Login:
Password:
Figure 9: Login and Password Prompts
4.Type netoptics and press Enter.
5.At the password prompt, type netoptics and press Enter. The NetOp- tics: prompt appear.
To change the username and password:
1.Change the username by typing the following command:
set username <username>
where <username> is your new username.
7