4xN 10/100/1000 Span iMatrix Switch
2.Change the password by typing the following command:
set password <password>
where <password> is your new password.
3.Record the username and password in a secure location.
To set the iMatrix Switch IP address:
1.Type set ip <ip address> where <ip address> is the IP address you are assigning to the iMatrix Switch and press Enter.
For example, typing set ip 10.60.0.100 sets the iMatrix Switch IP address to 10.60.0.100.
To display current settings:
1.Type show set and press Enter. The CLI displays the current settings similar to the example in Figure 10.
show set |
|
|
IP Address: | 10.60.0.123 | |
Netmask: | 255.255.0.0 | |
Manager: | 10.10.1.40 | |
Gateway: | 10.60.0.118 | |
HW Version: | REV 1.00 | |
SW Version: | REV 1.00 | |
Port 1 Parameters: | Gigabit | |
Port 2 | Parameters: | Gigabit |
Port 3 | Parameters: | Gigabit |
Port 4 | Parameters: | Gigabit |
Figure 10: Show Set Command Example
To disable the remote interfaces:
1.Type show display and press Enter to view the current setting. The default value is Display: ON.
2.Type display and press Enter. Access to the iMatrix Switch from remote interfaces will be blocked.
3.To restore the display and remote interfaces, type display and press Enter.
8