Net Optics ISW-CU3-S4x16 manual Overview, Installation Planning, Single iMatrix Switch Mode

Page 9

4xN 10/100/1000 Span iMatrix Switch

Chapter 2 Installing the iMatrix Switch

Overview

The procedure for installing the iMatrix Switch follows these basic steps:

•Plan the installation

•Conﬁgure IP parameters

•Mount the iMatrix Switch

•Connect the Management Port

•Connect to the network

•Connect to the monitoring devices

•Apply power to the iMatrix Switch

•Check the installation

Installation Planning

There are two methods for connecting your iMatrix Switch:

Single iMatrix Switch Mode

•A single monitoring device to controls the Monitor Ports of a single iMatrix Switch from one COM Port.

Daisy Chaining Mode

•Allows up to three iMatrix Switches to be controlled from one monitoring device or host PC.

Remote Access

The remote access features require that you assign an IP address to the iMatrix Switch. If you are daisy chaining iMatrix Switches, you only need an IP address for the Controller iMatrix Switch. You may also wish to assign a netmask.

If you plan to remotely control the iMatrix Switch over WAN, you can also set a gateway and IP address where you plan to use the SNMP management tool.

5

Image 9

Contents User Guide for 4xN 10/100/1000 Span iMatrix Switch Trademarks and Copyrights Contents Chapter Using System Manager Appendix B Command Line InterfaceAppendix a Speciﬁcations and Models Remote Control Scalable DeploymentReliability Passive, Secure Technology Key FeaturesEase of Use SupportAbout this Guide Unpacking and InspectionLED Indicators Product DiagramsSingle iMatrix Switch Mode Installation PlanningDaisy Chaining Mode Remote AccessConﬁguring the iMatrix Switch Using the Command Line Interface CLITo access the iMatrix Switch CLI Set username username To change the username and passwordTo set the iMatrix Switch IP address Set password passwordTo display current settings To disable the remote interfacesIMatrix Switch CLI Help Menu To use the Help commandConnecting to Switch Span Ports Connecting to the Monitoring Device3 4 5 6 7 Connecting Monitor Ports Connecting the Remote Interface PortTo daisy chain iMatrix Switches Daisy Chaining iMatrix SwitchesConnecting Daisy Chained Monitor Ports Connecting the Daisy Chain Control Ports To access Web Manager Accessing Web ManagerField Name Value Description Viewing Switch StatusField Name Function/Value Description Switch ControlMessage Board To install System Manger Installing System ManagerWelcome Dialog Box Conﬁrm Installation Installation Progress Exploring System Manager To access System ManagerTo create an iMatrix Switch group Using the ToolbarCreating a Group TipAdding iMatrix Switches Deleting a GroupTo delete a Group Adding a New iMatrix Switch To add an iMatrix Switch to the systemNet Optics System Manager with an iMatrix Switch Conﬁguring an iMatrix Switch Deleting an iMatrix SwitchTo delete an iMatrix Switch from System Manager To conﬁgure the iMatrix SwitchTo view iMatrix Switch information Viewing iMatrix Switch InformationFollowing table explains the status ﬁelds To modify the iMatrix Switch conﬁguration Modifying an iMatrix SwitchTo connect a Monitor Port to a Span Port Controlling Switch ConnectionsConnecting Monitor Port To enter Span Port Names and Notes Entering Port Names and NotesElectrical EnvironmentalMechanical Software Command Line InterfaceIMatrix Web Manager IMatrix System ManagerAppendix B Command Line Interface 4xN 10/100/1000 Span iMatrix Switch 4xN 10/100/1000 Span iMatrix Switch By Net Optics, Inc. All Rights Reserved