MRV Communications EM316E3SF manual Features, Requirements for Managed Module, Connectivity

Page 6

Fiber Driver

EM316E3 & EM316E3SF

Features

E3 conversion between coax media and fiber media

Supports ITU-T G.703, ITU-T G.823, and HDB3 standards

Supports Local, Remote and Line Loop back Test

Up to 100km Transmission on Single Mode or 7km on Multimode Fiber

Modules can be Inserted / Removed without powering off the chassis

Extensive Network Management Support when used with EM316NM

*For dB budget see: ftp://ftp.fiberdriver.com/pub/doc/spec/fiberdriver

Requirements for Managed Module

EM316NM Management Firmware version 4.0 or later

For firmware released version go to: ftp://ftp.fiberdriver.com/pub/software/em316nm

For firmware beta version go to: ftp://ftp.fiberdriver.com/pub/software/beta/em316nm

MegaVision Network Management version 1.20 or later

Connectivity

Connectors Used

Coax: 75 Ω BNC (2 connectors: 1 for TX, 1 for RX)

Fiber: SC, or SC-APC (for single fiber)

Cable Requirement

Coax: RG58/U (Max Length=900 feet)

Fiber: SC-SC fiber cable, or SC-APC fiber cable (for single fiber)

Port Description

Port# Port Description

Port 1 E3 Coax, Conforms to ITU-T G.703, ITU-T G.823, and HDB3 standards Port 2 E3 Fiber, Multi-Mode: 1310nm, 0-2km

 

 

Multi-Mode: 1310nm, 2-7km

 

 

Single Mode: 1310nm, 0-25km

 

 

Single Mode: 1310nm,

25-50km

 

 

Single Mode: 1550nm,

50-100km

 

 

 

 

P/N: 1226006-001, REV_L

 

PAGE 6

Image 6
Contents EM316E3SF Serial number How many employees work at installation site?Registration Card What network medium/media does your organization use ?EM316E3SF Fiber Driver EM316E3 & EM316E3SF Introduction Product DescriptionFeatures Requirements for Managed ModuleConnectivity Display Information LED Definition Typical ApplicationsFiber Optic Configuration Jumper Settings Factory DefaultTheory of Operation E3 Line Receiver to fiber optic TransmitterSwitch LPBK/NORM is set to OFF Hardware Installation Preparation Follow all Safety RegulationsDetermine the best location for the chassis Unpacking the unitUnit Installation Take out the required amount of blank panelsFiber Driver EM316E3 & EM316E3SF Troubleshooting Technical Specifications Customer Support Americas SupportInternational Support Glossary Ordering InformationFiber Driver Division of MRV Fiber Driver EM316E3 & EM316E3SF