Multi-Tech Systems MTSGSM manual Result Code

		Chapter 5 - AT Commands, S-Registers, and Error Codes
X	Extended result codes
Syntax	ATXn where n is as follows. Valid values of n is 0,1,2,3 and 4.
Description	The ATX command controls the result codes from the modem. In the table below an *
	indicates that the normal response is used and a number indicates what response
	will be used instead of the normal response. This value is stored in S-register 22 bit 4
	to 6.
	Result Code		X0	X1	X2	X3	X4
	0	OK	*	*	*	*	*
	1	CONNECT	*	*	*	*	*
	2	RING	*	*	*	*	*
	3	NO CARRIER	*	*	*	*	*
	4	ERROR	*	*	*	*	*
	5	CONNECT 1200	1.	*	*	*	*
	6	NO DIAL TONE	3.	3.	*	3.	*
	7	BUSY	3.	3.	3.	*	*
	8	NO ANSWER	1.	*	*	*	*
	9	CONNECT 600	1.	*	*	*	*
	10	CONNECT 2400	1.	*	*	*	*
	11	CONNECT 4800	1.	*	*	*	*
	12	CONNECT 9600	1.	*	*	*	*
	13	CONNECT 7200	1.	*	*	*	*
	14	CONNECT 12000	1.	*	*	*	*
	15	CONNECT 14400	1.	*	*	*	*
	16	CONNECT 19200	1.	*	*	*	*
	17	CONNECT 38400	1.	*	*	*	*
	18	CONNECT 57600	1.	*	*	*	*
	22	CONNECT 1200TX/75RX	1.	*	*	*	*
	23	CONNECT 75TX/1200RX	1.	*	*	*	*
	24	DELAYED	4	4	4	4	*
	32	BLACKLISTED	4	4	4	4	*
	33	FAX					*
	34	+FCERROR					*
	35	DATA					*
	40	CARRIER 300				*
	44	CARRIER 1200/75					*
	45	CARRIER 75/1200
	46	CARRIER 1200				*
	47	CARRIER 2400				*
	48	CARRIER 4800				*
	49	CARRIER 7200				*
	50	CARRIER 9600				*
	51	CARRIER 12000					*
	52	CARRIER 14400					*
	66	COMPRESSION: CLASS 5					*
	67	COMPRESSION: V.24bis					*
	69	COMPRESSION: NONE					*
	76	PROTOCOL:NONE					*
	77	PROTOCOL:LAPM					*
	80	PROTOCOL:ALT					*
	81	PROTOCOL:ALT-CELLULAR				*

MTSGSM 33