Note: See the Restore command and IP Escape String
command.
•
•
•
At the Login prompt, type admin.
At the Password prompt, type admin.
• After a successful login, the MultiConnect IP enters Command Mode. In Command Mode, the MultiConnect IP can be configured and managed using the Command Line Interface (CLI) command set.
About Command Mode and Data Mode
• In Command Mode, a # sign designates the prompt. If you type the word Help at the command prompt, a complete list of commands displays.
Upon successful establishment of a Telnet session, the MultiConnect IP displays the Login prompt.
•
Open the PPP interface on the modem port.
•
If you type the word Usage at the command prompt, a list of the command semantics displays. In Data Mode, the # sign is not displayed.
To leave Command Mode, exit your terminal or Telnet session or type the word Exit at the command prompt.
Chapter 3 – Managing and Configuring the MultiConnect Adapter
Chapter 3 – Managing and
Configuring the MultiConnect
Adapter
Two Ways to Login
Login Using TTY
• Use TTY to configure your MultiConnect IP for the first time. Configure the host serial port using the defaults listed below:
Baud: 115.2K
Data: 8
Parity: N
Stop: 1
• Press the Enter key three times to get to the Login prompt or send three carriage returns.
• At the Login prompt, type admin.
At the Password prompt, type admin.
Important: The user name and password are case sensitive. They must be typed in lowercase letters.
Login Using Telnet through the PPP Interface
11