Multi-Tech Systems MTS2BTA manual Connect the Adapter to Your System, Fused Fused Cable Connection

Page 10

Chapter 3 – AT Commands, S-Registers, and Result Codes

Step 2 – Connect the Adapter to Your System

Setup Example

This example shows a BlueTooth Adapter setup at a fixed site and ready to communicate with the Bluetooth Adapter at a remote location.

Connections for the MultiModem Using AC Power

Turn off your computer. Place the adapter in a convenient location, and then connect it to your computer’s serial port, the phone line, and AC power.

Connections for the MultiModem Using DC Power

For DC power, use the fused cable in place of the Universal Power Supply and the AC Power Cord.

Fused

Fused Cable

Cable

Connection

Installation Steps

RS-232 Connection

Plug one end of the serial cable into the RS-232 connector on the adapter and plug the other end into a serial port connector on your computer.

Power Connection

For AC – Plug the power supply cable with attached transformer block into the power connector on the MultiConnect. Then plug the AC cord receptacle into the transformer block, and plug the other end of the AC cord into a power outlet or power strip.

Note: Use only the power supply supplied with the Adapter. Use of any other power supply will void the warranty and could damage the adapter.

For DC – Plug the fused cable into the power connector on the MultiConnect. Then attach the two wires at the other end of the fused cable to a DC power source.

Multi-Tech Systems, Inc. Serial-to-Bluetooth Adapter User Guide (S000370A)

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents MultiConnect Adapter Revision Date Description 03/31/05 Contents Product Description Description SpecificationsFeatures ApplicationsHandling Precautions MultiConnect Package ContentsAT Commands Product Build OptionsVehicle Safety General SafetyMaintenance of the Serial-to-Bluetooth Adapter Technical Specifications LED Indicators SafetyInstallation and Cabling Attaching the Adapter to a Fixed LocationConnect the Adapter to Your System Fused Fused Cable ConnectionAT Command Reference Guide AT CommandsUsing AT Commands To Get Out of Data Mode and Check Status From Power UpFrom Power Up and No Connection ReplycrlfOKcrlfSent Aturst crlf Test Procedures Using AT CommandsReply OKcrlf Reply OK crlfDisabling Flow Control Using AT Commands Antenna Requirements Peripheral DevicesPin Assignments for the Serial Port International Adapter Restrictions EMC, Safety, and R&TTE Directive ComplianceAppendix a Regulatory Compliance Industry CanadaSouth African Statement New Zealand Telecom Warning NoticeOther Online Warranty Registration Appendix B Multi-Tech Warranty Statement and Product RepairWarranty Repair Procedures for U.S. and Canadian CustomersRepair Procedures for International Distributors Replacement PartsIndex
Top Page Image Contents