Blaupunkt Official Manual for Sydney CD Player - Connection Guide

SPEAKER CONNECTION INSTRUCTIONS

The unit’s Dual-Level Fader allows you to fade between the front and the rear channels using either the front and/or rear speaker leads and/or the rear preamp outputs, providing you tremendous flexibility in configuring your speaker arrangement:

•You can connect a speaker (regular, co-axial or tri-axial speakers or component speaker system, all hereafter referred to simply as “speaker”) to each of the units’ four pairs of speaker leads.

•With the purchase of Blaupunkt accessory wire harness 8 643 494 218, you can connect the

4 RCA preamp outputs to multiple external amplifiers and power multiple speakers or speaker systems through the amplifiers. (See below)

•You can use a either or both of these two methods.

•Blaupunkt amplifiers and speakers sold separately.

Connecting the Speaker Leads

To prevent short circuits or serious damage to the unit and/or speakers:

•Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery’s negative terminal before making connections.

•Only use speakers that have impedance ratings of 4 ohms or higher and have power-handling capabilities greater than the receiver’s stated power level.

•The unit’s internal amplifier is designed to handle a 4-ohm load on each pair of speaker leads.

•DON’T connect two soeakers to a sit-role oair of speaker leads (“in parallel”) unless both speakers each have at least 8 ohms impedance.

•DON’T connect the left and riqht speaker leads to each other or to the same speakers.

•DON’T connect the front and year speaker leads to each other or to the same speakers.

•DON’T connect the negative speaker leads to each other.

•DON’T connect the positive speaker leads to each other.

•DON’T connect any active speakers (with built-in amplifiers) to the speaker leads unless their owner’s manuals specifically state that this is O.K.

•Cover the ends of any unused leads with electrical tape. This will prevent them from touching the vehicle or each other and causing a short-circuit and damage to the receiver or vehicle.

PREAMP OUTPUT CONNECTION

Blaupunkt wire harness 8 634 494 218 frts In the top block on the rear of the unit. It rncludes 4-channel oreamo out connections, amolifrer switch-on lead (blue/white), and cellular telephone mute (dark green): If you purchase a Blaubunkt CDC-A05 or CDC-A071 CD Changer, you don’t need this harness because all of these connections are included in changer’s wire harness.

AUXILIARY INPUT

If a changer IS not connected, you can connect portable audro equipment to your unit by purchasing Blaupunkt accessory harness 7 607 890 093. This harness fits in the top block on the rear of the unit. It includes a 2 meter aux-in cable with a 3.5 mm male plug for direct insert into your portable equipment, as well as 4-channel preamp out connections, amplifier switch-on lead (blue), and cellular telephone mute (purple).

ItdELESS REMOTE CONTROLS

This receiver’s most-frequently used features can be controlled by Blaupunkt’s unique Thummer II Steerina-Wheel Remote Control. Included with remote control are a receiving “eye” that can be placed vrrtuallyanywhere on the dash, as well as a wiring harness, which can be used simultaneously with the harnesses for the preamp outout and for the changer or aux Input.