Remote Site Cable Connection | Multi-Tech Systems MVP110 specification

MultiVOIP Quick Start Guide

Remote Site Administrator

3.Unpack your MultiVOIP.

4.Connect one end of the power supply to a live AC outlet and connect the other end to the Power connection on your MultiVOIP.

Voice/Fax Channel

Connection

PHONE

ETHERNET

POWER

FXS

Power Connection

Ethernet Connection

Figure 5. Remote Site Cable Connection

5.Connect a network cable to the ETHERNET 10Base-T(RJ-45) connector on the back of your MultiVOIP.

6.If you are connecting a station device such as an analog telephone, a fax machine, or a Key Telephone System (KTS) to your MultiVOIP, connect one end of an RJ-11 cable to the Voice/Fax Channel 1 FXS connector on the back of the MultiVOIP and the other end to the station device.

7.Turn on power to the MultiVOIP by placing the ON/OFF switch on the right side panel in the ON position. Wait for the Boot LED on the MultiVOIP to go off before proceeding. This may take a couple of minutes.

8.At this time your VOIP network should be fully operational. Dial one of the sites in your network using the dialing directory supplied by your Network Administrator.