MicroNet Technology SP916GK Authentication, Type, Fragment, RTS Threshold, Beacon Interval

Page 17

Configuration

 

Open

Wireless AP can associate with this

 

System

wireless router without WEP

 

mode

encryption.

 

 

 

 

 

You should also set up WEP key in the

Authentication

Shared Key

"Security" page. Wireless AP

Type

mode

associated with this wireless router

 

 

should use WEP encryption in the

 

 

authentication phase.

 

Auto

The wireless client can associate with

 

this wireless router by using any one of

 

 

these two Modes.

Fragment

Specifies the

maximum size of packet during the

Threshold

data transition. The lower the values set, the poorer

 

the performance.

RTS Threshold

If the packet size is smaller the RTS threshold, the

wireless router will not send this packet by using the

 

RTS/CTS mechanism.

Beacon Interval

Specifies the period of time for a beacon broadcast.

 

 

 

The "Data Rate" is the highest limit for wireless

Data Rate

router transmission of data packets. The wireless

 

router will use the highest possible selected

 

transmission rate to transmit the data packets.

 

It defines the length of CRC block in the frames

Preamble Type

during the wireless communication. "Short

Preamble" is suitable for heavy traffic wireless

 

network. "Long Preamble" provides more

 

communication reliability

- 14 -

Image 17
Contents User’s Manual Table of Contents Management Product Specifications Appendix a GlossaryIntroduction Specifications Back Panel ResetLocal Area Network LAN Wide Area Network WANPWR Front PanelDhcp Server enabled Network configuration setupProcedures to configure IP addresses for your computer Page Wireless Router configuration setup Management Wireless RouterSetup Wizard Page Page Operation Mode Setup Configuration Basic SettingAdvanced Setting Active Wireless Client TableType AuthenticationFragment ThresholdSecurity Setting Access Control Setting Current Access WDS SettingComment Control listWAN Interface Setting TCP/IP Setting LAN Interface SettingDhcp Client Mode Static IP ModePPPoE Mode Password MTU Size Pptp ModeIP Address, Subnet Mask, Server IPCommon configurations for WAN interface Steps Firewall Configuration Port FilteringIP Filtering MAC Filtering Port Forwarding URL Filtering Virtual DMZ Management Status „ Wireless Configuration Mode„ System Uptime Firmware VersionWAN Configuration Attain IP Protocol LAN Configuration IP AddressDefault Gateway StatisticsSystem Log Time Zone SettingUpgrade Firmware Password Save and Reload SettingProduct Specifications Appendix a Glossary TCP FTP Smtp POP3