Milan Technology MIL-S3580 manual Led

Page 9
their meanings.

LED Indicators:

Figure 2-2. LED Indicators

All LED indicators are located on the front left panel of the MIL-S3580. They provide a real-time indication of system and operational status. The following table gives descriptions of the LED status and

LED

Status Description

PWR

Green

Power is on.

 

 

Off

Power is off.

 

 

 

Green

The port is operating at the speed of 100Mbps.

100

 

 

Off

No device attached or port is in 10Mbps mode.

 

 

 

 

 

Green

The port is connecting with the device.

LK/ACT

 

 

Blinks

The port is receiving or transmitting data.

 

 

 

 

Off

No device attached.

 

 

 

FD/COL

Yellow

The port is operating in Full-duplex mode.

 

 

Blinks

Collision of packets occurs in the port.

 

 

Off

No device attached or port is in half-duplex mode.

 

 

Table 2-1. Description of LED Indicators

9

Image 9
Contents MIL-S3580 Page 90000397A Introduction FeaturesManagement Features Management Methods Package ContentsSnmp Network Management Console and Telnet ManagementFront Panel Hardware DescriptionLED Power On Diagnostic TestRear Panel Mounting the Switch Pre-Installation RequirementsDesktop Mounting Rack-mounted InstallationMount the MIL-S3580 in an EIA Standard 19-inch Rack Connecting to the SwitchConnecting the MIL-S3580 to a Terminal via RS-232 Cable Login in the Console InterfaceUser Interface TelnetMain Menu First ScreenSystem Information Management SetupSerial Port Configuration Network Configuration11. Snmp Community Menu Snmp Community SetupTrap Receiver Management Capability SetupDevice Control Menu Trap Filter Setup16. Switch Device Configuration Menu Switch Device ConfigurationPage 17. Switch Port Configuration Menu Switch Port Configuration18. Switch Port Configuration Menu Individual Port Configuration19. Permanent Address Configuration menu Permanent/Static Address Configuration20. Static Unicast Address Configuration Menu Static Unicast Address Configuration21. Static Multicast Address Configuration Menu Static Multicast Address ConfigurationPort Statistics Spanning Tree Protocol ConfigurationPage Port-Based Vlan Configuration Spanning Tree Protocol Port Configuration25. Port Based Vlan Configuration Menu 1Q Vlan Configuration Console configuration Web configuration 27. Static Vlan Port Configuration Menu Dynamic Vlan Table Vlan Tagged Configuration30. MTU/MDU Per-Port Vlan Table MTU/MDU Per-Port Vlan Table31. Garp Configuration Menu Garp ConfigurationIgmp Snooping Table Trunk Group Configuration34. Port Mirroring Configuration Menu Port Mirroring Configuration35. User Authentication Menu User AuthenticationSystem Utility System Restart 36. User Authentication Detailed Menu38. Factory Reset Menu Factory ResetSystem Download Login Timeout IntervalQuick Start Configuration Update SettingAbout Web-based Management System LoginSystem Information Management Setup Snmp Community Setup Menu Trap Receiver Menu Trap Filter Setup Menu Device Control Switch ConfigurationPage VLANs are assigned 12. Switch Port Configuration Menu 13. Trunk Group in Switch Port Configuration Menu 14. Port Mirror in Switch Port Configuration Menu Port Mirror ConfigurationPermanent Address Configuration Spanning Tree Protocol Configuration 17. Spanning Tree Protocol Configuration Menu 19. Port Statistics Menu Static Vlan Configuration Vlan ConfigurationConsole configuration Web configuration Dynamic Vlan Table Menu 21. Static Vlan Configuration Menu23. Untagged Configuration Menu 26. Garp Configuration Menu 27. Igmp Configuration Menu Igmp Configuration28. User Authentication Menu User Authentication29. System Restart Menu 31. Login Timeout Interval Menu 31. System Download Menu Update SettingCollapsed Backbone Application Network ConfigurationCollapsed Backbone Application Departmental BridgeDepartmental Bridge Application High Performance Switched WorkgroupPort-based Vlan Workgroup12s Ieee 802.1Q Vlan ApplicationShared Server Page Product Specifications Page 90000397A