LED’s: The table below describes the operating modes:
LED | Color | Description |
| GREEN | Power is Applied |
|
|
|
| OFF | Power is OFF |
|
|
|
! | RED | Controller HW Error |
|
| |
|
|
|
| OFF | No Errors. Normal |
|
| Operation. |
|
|
|
LNK | GREEN | Link between ports |
| established | |
|
| |
|
|
|
| OFF | No Link between ports |
|
|
|
ACT | GREEN | Data is active between |
| ports | |
|
|
|
| OFF | Data is inactive between |
|
| ports |
|
|
|
APPLYING POWER (Side View)
Unscrew & Remove the DC Voltage Input Plug(s) from the side header Install the DC Power Cables into the Plug(s) (observing polarity).
Plug the Voltage Input Plug(s) back into the side header.
Tightening torque for the terminal block power plug is 0.22 Nm/0.162 Pound Foot. All LED’s will flash ON Momentarily (including the Error LED)
Verify the Power LED stays ON (GREEN). Verify the Error LED is OFF (after a few seconds).
Note: Only 1 plug is required to be connected to power input for minimal operation. For redundant power operation, V1 and V2 plugs must be connected to separate DC Voltage sources. Use wire sizes
Recommended 24V DC Power Supplies, similar to 100VAC/240VAC:
Rev 102507 | 10 |