Hardware Installation
Find a convenient spot near your computer for the Audiophile USB.With the Audiophile’s power switched “Off,” plug the included power supply into your wall socket, and plug its 2.5mm plug into the Audiophile’s 9V AC 1000 mA Power Jack.Then, simply connect the USB cable to your computer and to the Audiophile USB.
Please follow the Driver and Software installation carefully.Apply power to the Audiophile USB, switching the unit “On” ONLY when prompted.
Audiophile USB Driver & Software Installation
The Audiophile USB system includes a “Software Drivers CD” for Windows and Macintosh, containing all Windows and Macintosh drivers (including ASIO drivers), and Audiophile USB Control Panel software. To install on your system, please follow these steps:
Windows Installation
An “Installer” program is provided for Windows operating systems. The Audiophile USB Installer greatly simplifies the work that the Windows New Hardware Wizard has to do, and helps to ensure a
You may also notice that a “Windows Driver Signing” dialog box will pop up a few times during the installation, and you will be asked to press “Continue Anyway.” This dialog box indicates that this is a relatively new product. While we are going through the driver certification procedure with Microsoft, we assure you that your Audiophile USB drivers are of the highest quality, and will cause no problems in your system.
1.Insert the Drivers CD into your CD ROM drive. Locate and open the Audiophile USB folder. Double click on the Audiophile USB Installer program in that folder.
2.As the Installer loads the Audiophile USB drivers, a “Windows Driver Signing” (XP and 2000 Users only) dialog box may pop up a few times during the installation. Click,“Continue Anyway.”
3.When asked to switch “On” your Audiophile USB, do so.This will bring up the Windows New Hardware Wizard. Click “Next” at each prompt, and the Hardware Wizard should automatically recognize all of the Audiophile Drivers.
NOTE: Windows 98SE users will need their Microsoft Windows 98SE
6