Regency U32-NG3 Log Set Installation, A02-43, D02-46, C02-56, B02-45, E02-47, F02-48

INSTALLATION

LOG SET

INSTALLATION

Read the instructions below carefully and refer to the diagrams. If logs are broken do not use the unit until they are replaced. Broken logs can interfere with the pilot operation.

The gas log kit contains the following:

a)02-43 Rear Log

b)02-45 Front Right Log

c)02-56 Middle Left Log

d)02-46 Left Top Log

e ) 02-47 Center Log

f)02-48 Middle Right Log

g)02-44 Front Left Log

h)Embers

i)Rockwool

j)Vermiculite

3) Place Rear Log A)02-43 on the two pins on	6) Place the Left Top Log D)02-46 on the pin
the rear log support.	on Log	C)02-56 and on top of the cutout
	on Log A)02-43.
A)02-43
	D)02-46
		A)02-43
		C)02-56
Pins on Rear Log Support
	Pin	Cutout

4) Place Front Right Log B)02-45 on the two

7) Place the notch in Center Log E)02-47 over

pins as shown.

Log B)02-45 and across the cutout on Log A)02-43.

Note: Install Optional Brick Panels prior to installing logs.

B)02-45 E)02-47 A)02-43

B)02-45

5)Place the Middle Left Log C)02-56 on the

two pins as shown. Notch Cutout

The "02" refer numbers (i.e. 02-43) are

molded into the rear of each log.

1)Carefully remove the logs from the box and unwrap them. The logs are fragile, handle with care - do not force into position.

2)Sprinkle the vermiculite around the firebox base. Take some of the embers (approx. 1/3 of the bag) and sprinkle over the ver- miculite.

Vermiculite and	Vermiculite and	Vermiculite and
embers.	embers.	embers.

C)02-56

Logs D)02-46 and E)02-47 in position.

8)Position notch in Front Right Log F)02-48 on Log E)02-47 and push the bottom right edge against the bracket on the burner tray and the front edge of the rear burner.

F)02-48

Logs A)02-43, C)02-56,

and B)02-45 in position

B)02-45

Notch Bracket

U32-3 FPI Direct Vent Gas Insert 9