MaxTech V.34/V.42bis user manual Contents

Page 2

Contents
Section One - Introduction	1
Section Two - Installation	1
Section Three - AT Command Set	7
Section Four - S Registers	13
Section Five - Result Codes	15
Section Six - Troubleshooting	15
Section Seven - Support and Service	17
Appendix A - Specifications	17
Appendix B - Speaker Type Selection	18
Appendix C - Notices	18

The information contained in this manual has been validated at the time of this manual's production. The manufacturer reserves the right to make any changes and improvements in the product de- scribed in this manual at any time and without notice. Consequently the manufacturer assumes no liability for damages incurred directly or indi- rectly from errors, omissions or discrepancies be- tween the product and the manual.

All registered trademarks are the property of their respective owners.

Copyright © 1996 All rights reserved. No repro- duction of this document in any form is permitted without prior written authorization from the Manu- facturer.

Image 2

Contents MAN080 Rev SF-1128HV/R16-PnP Contents Section One Introduction Section Two InstallationInstall Windows Unpacking Your ModemBack Plate Hardware InstallationExpansion Slots Replace the computer cover and plug in your com- puter Hardware Configuration Plug and PlayConfiguring in Windows Configuring in a Plug and Play System without Windows Configuring in a Non-Plug and Play SystemSoftware Installation and Configuration Where To Go From Here Testing Your Modem After InstallationUsing Your Modem Command Structure Section Three AT Command SetExecuting Commands Basic AT CommandsLow speaker volume Commands are not echoedCommands are echoed Enable Autoscan modeExtended AT Commands Disable auto-retrain Force DSR Signal High onPower on or reset CTS operates per flow controlMNP/V.42/V.42bis Commands Fax Class 1 Commands Fax Class 2 CommandsVoice Commands Section Four S RegistersRegister Function Range/units Default S RegistersSection Five Result Codes Section Six TroubleshootingModem does not respond to commands Modem makes a connection but no data appears on your screen Modem does not dialModem dials but does not connect High pitch tone is heard whenever you answer the phoneModem exhibits poor voice record or playback Section Seven Support and ServiceAppendix a Specifications FCC Compliance Appendix B Speaker Type SelectionAppendix C Notices FCC Class B Statement DOC Compliance InformationUL Notice