MaxTech V.34/V.42bis Appendix B Speaker Type Selection, Appendix C Notices, FCC Compliance

Page 20

Data format:

300-115200 bps

Power:

0.75 W

Temperature:

0 to 55 degrees C (Operating)

Caller ID:

Yes

PnP:

Revision 1.0a

Speakerphone:

Full-duplex with DSP echo

 

cancellation

 

 

Appendix B - Speaker Type Selection

Your modem supports both mono and stereo speakers. Use jumper JP3 to select the speaker type. The modem is factory set to use stereo speakers (jumper over both pins). If you use a mono speaker, remove the jumper (See Figure B-1).

Figure B-1 Speaker Type Jumper JP3

STEREO MONO

Appendix C - Notices

FCC Compliance

This equipment complies with Part 68 of the FCC Rules. On this equipment is a label that contains, among other information, the FCC registration number and Ringer Equivalence Number (REN) for this equipment. You must, upon request, provide this information to your telephone company.

If your telephone equipment causes harm to the telephone network, the Telephone Company may discontinue your ser- vice temporarily. If possible, they will notify in advance. But, if advance notice is not practical, you will be notified as soon as possible. You will be informed of your right to file a complaint with the FCC.

Your telephone company may make changes in its facilities, equipment, operations, or procedures that could affect proper operation of your equipment. If they do, you will be notified in advance to give you an opportunity to maintain uninterrupted telephone service.

The FCC prohibits this equipment to be connected to party lines or coin-telephone service.

In the event that this equipment should fail to operate properly, disconnect the equipment from the phone line to determine if it is causing the problem. If the problem is with the equipment, discontinue use and contact your dealer or vendor.

18

Page 19 Page 21
Image 20
Page 19 Page 21
Contents MAN080 Rev SF-1128HV/R16-PnP Contents Section Two Installation Install WindowsSection One Introduction Unpacking Your ModemBack Plate Hardware InstallationExpansion Slots Replace the computer cover and plug in your com- puter Hardware Configuration Plug and PlayConfiguring in Windows Configuring in a Plug and Play System without Windows Configuring in a Non-Plug and Play SystemSoftware Installation and Configuration Where To Go From Here Testing Your Modem After InstallationUsing Your Modem Section Three AT Command Set Executing CommandsCommand Structure Basic AT CommandsCommands are not echoed Commands are echoedLow speaker volume Enable Autoscan modeExtended AT Commands Force DSR Signal High on Power on or resetDisable auto-retrain CTS operates per flow controlMNP/V.42/V.42bis Commands Fax Class 1 Commands Fax Class 2 CommandsVoice Commands Section Four S RegistersRegister Function Range/units Default S RegistersSection Five Result Codes Section Six TroubleshootingModem does not respond to commands Modem does not dial Modem dials but does not connectModem makes a connection but no data appears on your screen High pitch tone is heard whenever you answer the phoneModem exhibits poor voice record or playback Section Seven Support and ServiceAppendix a Specifications FCC Compliance Appendix B Speaker Type SelectionAppendix C Notices FCC Class B Statement DOC Compliance InformationUL Notice
Top Page Image Contents