®
|
|
| Table of Contents |
|
1 | General | 1 | ||
| 1.1 | Introduction | 1 | |
| 1.2 | Firmware Revision | 1 | |
| 1.3 | Features | 1 | |
| 1.4 | Quick Install | 1 | |
2 | Installation | ............................................................................................................................ | 2 | |
| 2.1 | Unpacking the Box | 2 | |
| 2.2 | Choosing a Mounting Location | 2 | |
|
| 2.2.1 Mounting Location When Used With Analog Gauge(s) | 2 | |
|
| 2.2.2 Mounting Location When Used Without Analog Gauge(s) | 3 | |
| 2.3 | Connecting the RAA100 | 4 | |
|
| 2.3.1 Connecting Attached Gray Cable to Analog Gauge or Rudder Sender | 4 | |
|
|
| 2.3.1.1 Connecting Attached Gray Cable to Analog Gauge | 5 |
|
|
| 2.3.1.2 Connecting Attached Gray Cable to Rudder Angle Sender | 5 |
|
| 2.3.2 Connecting to NMEA 2000® Interface | 5 | |
3 | Configuring the RAA100 | 6 | ||
| 3.1 | Configuring Rudder Instance Number | 6 | |
| 3.2 | Configuring Operating Mode | 7 | |
|
| 3.2.1 Configuring Analog Gauge Resistance | 7 | |
|
|
| 3.2.1.1 Power Terminal to Sensor Terminal Resistance Measurement | 7 |
|
|
| 3.2.1.2 Ground Terminal to Sensor Terminal Resistance Measurement | 7 |
| 3.3 | Standard Sender Selection or Custom Calibration | 8 | |
|
| 3.3.1 | Standard Sender Selection | 8 |
|
| 3.3.2 | Custom Calibration | 8 |
4 | Maintenance | 8 | ||
5 | Troubleshooting | 9 | ||
6 | Technical Specifications | 10 | ||
7 | Technical Support | 11 | ||
8 | Maretron (2 Year) Limited Warranty | 12 | ||
Revision 1.0 | Page iii |