Page 8 - Setting Up the 20DS
Setting Up the 20DS
Associating the 20DS
Before using the 20DS, you must associate it with an INDeX terminal. You can associate several 20DS's with the same terminal if required (to reassociate a 20DS with a different terminal after setting up the DSS keys, see page 9).
To associate a 20DS:
1.Ensure that the unit's power supply is connected and switched on (the BLF lights should flash briefly and the unit gives a short ring).
2.Plug the unit's line cord into its LINE socket (on the base of the unit) and then into an INDeX system phone socket .
3.The units BLF lamps come on in the pattern shown below:
Green and Red
Flashing Keys
Solid Green
Number Pad
Keys
Red Clear Key
–The green and red flashing lamps indicate associate mode.
–The solid green DSS keys form a dialling pad matching keys 1 to 9 and 0 on 2030/50/60 phone or the 20CC turret.
–The lower solid red DSS key acts as a clear key.
4.Using the solid green DSS keys, dial the number of the display phone with which you want the unit associated.
–If you misdial part of the number, use the bottom solid red DSS key to clear the whole entry.
–If the number dialled is not an extension, the unit clears the number entered.
–If the number dialled is okay, all the lights go out. You can now program the DSS keys (see page 9).
INDeX 20DS User's Guide | 38DHB0002UKCN – Issue 3 March 2000 |