Setting Up the 20DS – Page 9
Programming the DSS Keys
DSS Keys - Alias:
-Line keys.
-F Keys.
-Repertory dialling.
You can program each DSS key with a line, extension or group directory number. Once programmed, the key's BLF lamp displays the status of that number and call to that number (e.g. free, busy, ringing, etc). Alternatively, you can program a key with a system speed dial number.
To program a DSS key:
1.Press PROGRAM and then the DSS key to use.
2.Enter the phone's passcode.
3.The display shows the current stored number (if set).
4.Press 
CANCEL to clear the stored number.
5.Enter the number to store:
–For an extension, line or group number, simply dial the directory number to store.
–For a system speed dial number, press the SPEED DIAL key and dial the required speed dial store number.
6.Select another DSS key or press 
DONE.
7.Press PROGRAM to finish.
Reassociating a DSS Unit
You can change the phone with which the 20DS is associated without physically moving the unit. This saves having to reprogram the DSS keys. The associated phone must still be a INDeX display phone.
To reassociate a 20DS:
1.Switch off the unit's power supply.
2.While holding down any two DSS keys in different columns, switch the unit's power supply back on.
3.The unit should switch back on with the top keys flashing alternate green and red. Continue from Step 3 of associating a 20DS (see page 8).
Clearing Settings
Inserting any other type of phone (even temporarily) into the 20DS's socket, erases all the 20DS's programming. If the 20DS is reconnected you must associate it with a INDeX display phone again (see "Associating the 20DS" on page 8) and then reprogram the DSS keys (see above).
38DHB0002UKCN – Issue 3 March 2000 | INDeX 20DS User's Guide |