Lucent Technologies 8403 manual Select Ring and Ringer Volume

Select Ring (and Ringer Volume)

✔

To select a personalized ring 1 While on-hook, press

• Red light next to process

Feature

Feature

, and then press Hold

blinks during the Select Ring

•Voice terminal plays the current ringing pattern

2Press

Hold

again to hear the next ringing pattern

Note: There are eight different patterns; the cycle repeats after the last pattern.

3When you hear the desired ringing pattern,

press Feature

•Your new ringing pattern is set; the selection process ends

•Red light next to Feature goes off

Note: If you receive a call, go off-hook, or lose power during selection, the process is interrupted and you must start again.

To adjust ringer volume	1 While the handset is on-hook and the speaker is off, or if the
if necessary	voice terminal is ringing when the handset is off-hook:
	Raise the volume by pressing the right half of the
	Volume control button labeled	;
	or lower the volume by pressing the left half of the
	Volume control button labeled

(There are eight possible volume settings.)

19