Lucent Technologies 7820-0657-001 manual Setting up the DSLPipe DSU, Package contents

Page 16

Setting up the DSLPipe DSU

	1
2	3
	3
	5
	4

Figure 2-1. Package contents

Setting up the DSLPipe DSU

Figure 2-2 shows the DSLPipe DSU’s rear panel. To set up your DSLPipe DSU, you use components located on the rear panel to set the data transmission rate, configure the unit as either CPE or COE, and connect the necessary cables

Figure 2-2.DSLPipe DSU Rear Panel

DC IN

RATE

V.35

TERMINAL

WAN

2-2	DSLPipe DSU (SDSL) User’s Guide

Image 16

Contents DSLPipe DSU Sdsl Lucent Technologies Customer Service Enabling Lucent to assist youOther telephone numbers Important safety instructions Important safety instructionsImportant safety instructions Special Requirements Important safety instructions Contents Page Introduction DSLPipe DSU features DSLPipe DSU configurationDSLPipe DSU architecture DSLPipe DSU architecturePage Installation Checking package contentsSetting up the DSLPipe DSU Package contentsSetting the data transmission rate Connecting the cables Checking the activity of the LED lightsLocation of the LED lights in the DSLPipe DSU front panel Page Viewing configuration information Items you needBits per second Specify Data bits Specify Viewing configuration information Viewing configuration informationIndicates Norm Normal or Rev Reverse. The default is Viewing diagnostic information Debug Mode windowFields in the Hdlc Registers list Shows Working if the V.35 line is working. Otherwise, shows Page Hardware Specifications Table A-1. DSLPipe DSU specificationsPage Product warranty Warranties and FCC RegulationsWarranty repair FCC Part 15 NoticeIC CS-03 Notice IC CS-03 Notice