Lucent Technologies 7820-0657-001 manual Viewing configuration information, Items you need

Page 21

Viewing configuration information

3

 

 

 

Items you need . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1

Connecting serial cable and setting up communications software . . . . . . . . 3-1

Viewing configuration information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3

Viewing diagnostic information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5

Before you can view the configuration information for the DSLPipe unit, you must set up VT100 emulation to view the on-board software.

Items you need

You need a serial cable that can plug into an available, enabled serial port on your computer. The other end of the cable must have a male DB-9 connector to fit the serial port connector on the back of the DSLPipe unit. If your computer is a Macintosh, the cable must fit the modem port’s nine-pin mini DIN connector.

You also need communications software that supports VT100 emulation.

Connecting serial cable and setting up communications software

To establish a serial connection, proceed as follows:

1Use a serial cable to connect your computer’s serial (or modem) port to the terminal port on the back of the DSLPipe unit.

DSLPipe DSU (SDSL) User’s Guide

3-1

Image 21
Contents DSLPipe DSU Sdsl Lucent Technologies Enabling Lucent to assist you Customer ServiceOther telephone numbers Important safety instructions Important safety instructionsImportant safety instructions Special Requirements Important safety instructions Contents Page Introduction DSLPipe DSU configuration DSLPipe DSU featuresDSLPipe DSU architecture DSLPipe DSU architecturePage Checking package contents InstallationPackage contents Setting up the DSLPipe DSUSetting the data transmission rate Checking the activity of the LED lights Connecting the cablesLocation of the LED lights in the DSLPipe DSU front panel Page Items you need Viewing configuration informationBits per second Specify Data bits Specify Viewing configuration information Viewing configuration informationIndicates Norm Normal or Rev Reverse. The default is Debug Mode window Viewing diagnostic informationFields in the Hdlc Registers list Shows Working if the V.35 line is working. Otherwise, shows Page Table A-1. DSLPipe DSU specifications Hardware SpecificationsPage Warranties and FCC Regulations Product warrantyFCC Part 15 Notice Warranty repairIC CS-03 Notice IC CS-03 Notice