Macsense Connectivity MIH-130 user manual Mac OS TCP/IP Configuration

Page 17

Easy Installation

Mac OS TCP/IP Configuration

1.Open the TCP/IP control panel.

2.In the Connect via menu select the Ethernet interface that is installed on your computer.

3.In the Configure pull-down menu that appears, select Using DHCP Server to allow the built-in DHCP server of the XRouter Pro to assign an IP address and other TCP/IP configuration information to the client automatically. Do this for each client that needs Internet access through the XRouter Pro.

(Note: The DHCP Client ID field is not require to connect to the XRouter Pro. It is normally used to identify computers in a DHCP network. If you desire to input the name of computer in this field, you may. )

4.Close the TCP/IP window and save the changes.

12

Image 17

Contents User’s Manual XRouter Pro Copyright Safety Precautions Table of Contents Page About this Manual Chapter ContentIntroduction Sharing Internet AccessPort Switched Ethernet Hub Inside Package Overview Before YOU StartConnecting the XRouter Pro to Your Modem Easy InstallationHardware Installation To connect computers directly to the XRouter Pro Connecting Computers to the XRouter ProConnecting the Power Supply Setting Up TCP/IP Software ConfigurationEasy Installation Easy Installation Assigning TCP/IP Values Manually Mac OS TCP/IP Configuration Assigning TCP/IP Values Manually Setting Up the XRouter Pro Through a Web Browser Easy Installation Select Specify an IP Address Easy Installation Dhcp Server Settings Advanced ConfigurationAccess Control Virtual Server Device Administration RIP Routing Information Protocol DMZ DeMilitarized Zone HostLAN PPPoE Settings Xxxxx.bin Firmware UpgradeAdvanced configuration Link LED is off TroubleshootingPower DimensionsStandards Compliance WAN InterfaceAppendix B Hardware Description Rear Panel Description Internet Dynamic IP addressDomain Name Local Area Network LAN IP AddressMAC Address PPPoE Point to Point Protocol over EthernetTCP/IP Static IP address