Macsense Connectivity MIH-130 user manual Safety Precautions

Page 3

Safety Precautions

1.Follow all warnings and instructions marked on the product.

2.Slots and openings on the device are provided for ventilation. To protect it from overheating, these openings must not be blocked or covered.

3.Do not use or store this product in an environment that exceeds temperature and humidity specifications. Do not place this product near a radiator or heat register, or in a built-in installa- tion unless adequate ventilation is provided.

4.Before cleaning this product, unplug from wall outlet. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

5.Do not place cords or cables where they may be walked on or tripped over.

6.Be sure to comply with any applicable local safety standards or regulations.

7.General purpose cables are provided with this product. Any cables or other requirements mandated by local authority are your responsibility.

8.Cables that are attached to devices in different locations that have different power sources and grounding may have hazardous voltage potentials. Consult a qualified electrical consultant before installing the product to see if this phenomenon exists and, if necessary, take corrective action.

9.Never touch annunciated telephone wires or terminals unless the line has been disconnected.

10.Avoid using telephone equipment or installing the product during an electrical storm.

11.Never install telephone jacks, lines, network cables, this product, or power connections in wet locations.

12.Never spill liquid of any kind on the product.

ii

Image 3
Contents User’s Manual XRouter Pro Copyright Safety Precautions Table of Contents Page About this Manual Chapter ContentIntroduction Sharing Internet AccessPort Switched Ethernet Hub Inside Package Overview Before YOU StartEasy Installation Hardware InstallationConnecting the XRouter Pro to Your Modem To connect computers directly to the XRouter Pro Connecting Computers to the XRouter ProConnecting the Power Supply Setting Up TCP/IP Software ConfigurationEasy Installation Easy Installation Assigning TCP/IP Values Manually Mac OS TCP/IP Configuration Assigning TCP/IP Values Manually Setting Up the XRouter Pro Through a Web Browser Easy Installation Select Specify an IP Address Easy Installation Dhcp Server Settings Advanced ConfigurationAccess Control Virtual Server Device Administration RIP Routing Information Protocol DMZ DeMilitarized Zone HostLAN PPPoE Settings Xxxxx.bin Firmware UpgradeAdvanced configuration Link LED is off TroubleshootingWAN Interface DimensionsPower Standards ComplianceAppendix B Hardware Description Rear Panel Description Dynamic IP address Domain NameInternet PPPoE Point to Point Protocol over Ethernet IP AddressLocal Area Network LAN MAC AddressTCP/IP Static IP address