Macsense Connectivity MIH-130 user manual Advanced Configuration, Dhcp Server Settings

Page 23

Advanced Configuration

ADVANCED CONFIGURATION

Please refer to the previous chapter on how to enter the Web

Management page of the XRouter Pro. The Advanced Menu contains nine sub-menus including DHCP Settings, Access Control, Virtual Server, Device Admin, Status Monitor, DMZ Host, RIP, Static Routing

and PPPoE.

DHCP Server Settings

To alter the starting IP Address range, the number of users that are automatically assigned IP addresses on the LAN, or to disable the DHCP server, you must enter the DHCP Settings page to make

changes.

18

Image 23

Contents User’s Manual XRouter Pro Copyright Safety Precautions Table of Contents Page About this Manual Chapter ContentIntroduction Sharing Internet AccessPort Switched Ethernet Hub Inside Package Overview Before YOU StartConnecting the XRouter Pro to Your Modem Easy InstallationHardware Installation To connect computers directly to the XRouter Pro Connecting Computers to the XRouter ProConnecting the Power Supply Setting Up TCP/IP Software ConfigurationEasy Installation Easy Installation Assigning TCP/IP Values Manually Mac OS TCP/IP Configuration Assigning TCP/IP Values Manually Setting Up the XRouter Pro Through a Web Browser Easy Installation Select Specify an IP Address Easy Installation Dhcp Server Settings Advanced ConfigurationAccess Control Virtual Server Device Administration RIP Routing Information Protocol DMZ DeMilitarized Zone HostLAN PPPoE Settings Xxxxx.bin Firmware UpgradeAdvanced configuration Link LED is off TroubleshootingWAN Interface DimensionsPower Standards ComplianceAppendix B Hardware Description Rear Panel Description Internet Dynamic IP addressDomain Name PPPoE Point to Point Protocol over Ethernet IP AddressLocal Area Network LAN MAC AddressTCP/IP Static IP address