2 Demonstration Kit
Configuration for Modem Control
By default, on this demo board, the DCD and DSR signals are not routed to the XPort module. This makes it necessary to jumper the pins in JP6 in order to route the signals to the desired CPs on the XPort module.
To be specific, if you wanted to route the serial port DCD signal to CP3 in order to take advantage of the modem control mode, you would place a jumper wire between JP6 pin 11 (the DSR signal from the serial port) to JP6 pin 10 (the CP3 pin from the XPort module).
Demo Board Layout
Figure 2-2. XPort Demo Board Layout
XPort™ Universal Demo Board User Guide | 9 |