LevelOne WPC-0100 manual Additional Note for Windows NT4.0

Additional Note for Windows NT4.0

The installation procedure under Windows NT4.0 will be a little different from Windows 98 shown below. It will be change after step10 refer to the installation of Windows 98.

1.Click “ OK “ and system will auto-select I/O address and IRQ and remind you to choose the unused I/O address and IRQ from Windows NT Diagnosis to prevent system resource conflict.

2.If the Ndis 3.0 packet driver has already existed in your system, the setup message will be prompted as follows, just click “ OK “.

3.A prompt of networking setting will appear as follows. It’s the same as Windows 98 operating system.

8