Table of Contents
Introduction | 1 |
System Design | 1 |
Theory of Operation of the LAVA | 1 |
Primary Hardware Components of the | 2 |
ST Plus | 2 |
HQ Plus | 3 |
Secondary Hardware Components of the | 4 |
HQ Remote Console | 4 |
HQ Remote Poller | 4 |
Software Components of the | 5 |
HQ Basic Software | 5 |
ST Plus Configuration Console | 5 |
LAVA Ether Link Manager Utility | 5 |
LAVA HQ Plus Install | 6 |
Equipment Needed | 6 |
General | 6 |
METHOD #1: Headquarters Installation using | 6 |
METHOD#2: Headquarters Installation using Ether Link Manager and the Web Page | 9 |
LAVA ST Plus Install | 12 |
Equipment Needed | 12 |
General | 12 |
Installation of ST Plus Devices at the ECR Equipment Sites | 12 |
ST Configuration Console: Operation | 16 |
Hardware Connection | 16 |
Software Connection | 16 |
HQ Basic: Operation | 19 |
Hardware Connection | 19 |
Software Connection | 19 |
APPENDIX A: Installation Checklist | 21 |
APPENDIX B: Verify Access to the Internet from the LAN | 23 |
APPENDIX C: Check that the LAN Provides DHCP Setting Configurations to Devices on the LAN | 24 |
APPENDIX D: Check that the Selected HQ Site has a STATIC WAN IP Address | 25 |
APPENDIX E: Test that the HQ Site is Properly Set Up and Working: HQ Plus Installed | 26 |
APPENDIX F: Test the | 27 |
APPENDIX G: Troubleshooting | 28 |
APPENDIX H: Master Reset to Factory Defaults | 30 |
APPENDIX I: Installing the HQ Plus on the PC as a (TAPI) Modem | 31 |
APPENDIX J: Windows Installation Tools for Use with HQ Plus and ST Plus Devices | 32 |
Web Page Interface on HQ Plus and ST Plus | 32 |
PING Function | 32 |
IPCONFIG Function | 32 |
HyperTerminal | 32 |
TELNET | 32 |
Rev. A00 | Page i |