ST Configuration Console: Operation
The ST Configuration Console provides a
It also provides an interface for supplying
Hardware Connection
The ST Configuration Console software runs on a host PC that has a serial port connected to the serial port of the ST Plus device, using a
Software Connection
NOTE: The ST Plus Configuration Console software can only establish a connection to the attached ST Plus in the five second interval following the powering on of the ST Plus device. The serial port of an ST Plus device is designed to fall back to an operational mode after this
To establish a connection between the ST Plus and the ST Plus Configuration Console, follow the following steps:
1.Connect the serial port of the ST Plus to the serial port of the host PC that the ST Plus Configuration Console will use.
2.Start the ST Plus Configuration Console software.
3.Ensure that the serial port selected in the dialog box at the bottom left of the ST Configuration Console screen matches the physical port that is cabled to the ST Plus device.
4.Click on the “Connect” button.
5.Cycle the power on the ST Plus device. The ST Plus Configuration Console will detect that an ST Plus is attached and available, and query the device.
6.Data from the ST Plus will populate the fields of the ST Plus Configuration Console, and the word “Connected” will appear at the top of the ST Plus Configuration Console screen (see below).
Rev. A00 | Page 16 of 32 |