IMC Networks AccessEtherLinx/4 operation manual Base Vlan Priority, Port Configuration

When using dlsecure mode, configure the Uplink port for Tags in order for it to accept VLAN tagged traffic. Assign up to 15 VLAN IDs to the Uplink port and then assign one of those VLAN IDs to each Downlink port and SNMP.

Base VLAN Priority

The Uplink port has two outgoing queues; one for high priority traffic and one for low priority traffic. iView² can set a Base VLAN Priority to designate what will be high priority and low priority; the default value is 4. If the Base VLAN Priority is 4, 0-3 are low priority and 4-7 are high priority. If the Base VLAN Priority is 3, 0-2 are low priority and 3-7 are high priority. In the VLAN Configuration screen (shown above), a Priority (0 - 7) can be entered for each port and SNMP.

Port Configuration

The AccessEtherLinX/4 ports can be configured via serial configuration. Type ports and press Enter to be taken to the Port Configuration screen. From this screen, users can enable/disable ports, configure FiberAlert and Auto Negotiation, etc. (This can also be performed via iView².)

13