Paradyne Hotwire M/SDSL and HDSL2 Termination Units, 8747, 8777 Table A-7. System Options 1

Configuration Options

System Options

For System Options, refer to Table A-7. To access the System Options screen, follow this menu selection sequence:

Main Menu → Configuration → Load Configuration From →

main/config/system
Slot: 18		Model: 87xx
SYSTEM OPTIONS
DSL Mode:	LTU
Test Timeout:	Enable
Test Duration (min):	10
Telco Initiated Loopbacks:	Enable	(Models 8747, 8777)
Remote Telco Line Loopback:	Disabled	(Models 8747, 8777)
G.703 Line Termination	120 Ohm	(Model 8779)

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions, ESC for previous menu MainMenu Exit Save

Table A-7. System Options (1 of 2)

DSL Mode

Possible Settings: LTU, NTU

Default Setting: LTU

Controls whether the unit is configured as a control unit or tributary unit.

LTU – The unit is configured as a control unit (Line Termination Unit).

NTU – The unit is configured as a tributary unit (Network Termination Unit). This unit will request its IP address from the LTU during establishment of the PPP link.

NOTE: Changing this option will reset the card.

Test Timeout

Possible Settings: Enable, Disable

Default Setting: Enable

Allows tests to end automatically. The feature should be enabled when the unit is remotely managed, so that control can be regained after a test is accidentally executed.

Enable – Loopback and pattern tests end when test duration is reached.

Disable – Tests run until manually terminated from the Network Tests screen or remotely (network initiated tests). Refer to Running Network Tests in Chapter 8, Testing.

Test Duration (min)

Possible Settings: 1–120

Default Setting: 10

Number of minutes for a test to be active before automatically ending.

HTest Duration (min) option appears when Test Timeout is enabled.

1 to 120 – Amount of time in minutes for a test to run before terminating.

8700-A2-GB20-00 April 2000 A-11