Paradyne Hotwire M/SDSL and HDSL2 Termination Units, 8747, 8777 IP Addressing, All Configurations

IP Addressing

5

Selecting an IP Addressing Scheme

Your IP addressing scheme depends in part whether the management card controlling the chassis is running IP Conservative software.

Configurations Not Running IP Conservative Software

In a configuration not running IP Conservative software, the NTU’s network interface IP address is assigned through the peer IP address of the LTU’s Network Interface menu.

The termination unit is assigned an IP address and subnet through the DSLAM’s Configuration → DSL Cards → Set IP Address menu. Once the address is assigned, you can use the ATI to assign:

HPeer IP addresses to the DSL ports. These addresses are used as the IP addresses of the remote units, and must be in the same subnet as the DSLAM management card. See Table A-1,Network Interface Options, in Appendix A, Configuration Options.

HAn IP address for each NMS to act as a trap manager. See Table A-14, SNMP Traps Options, in Appendix A, Configuration Options.

All Configurations

The NTU obtains its IP address when the PPP link is established over the EOC.

Use the ATI to assign:

HAn IP address for each NMS. See Table A-13,SNMP NMS Security Options, in Appendix A, Configuration Options.

HAn IP address for the TFTP server you wish to use to upload and download configurations. See Configuration Loader in Chapter 9, Transferring Code and Configurations Using TFTP, and the documentation for your TFTP server.

8700-A2-GB20-00 April 2000 5-1