Paradyne 8777, 8747, 8779 manual Test Status Messages Meaning, Re presentative for assistance

Monitoring and Troubleshooting

Table 7-2. Self-Test Results Messages (2 of 2)

Message	What Message Indicates	What To Do
PLD Failure	An error was detected in a	1.	Reset the unit and try again.
	Programmable Logic Device.	2.	Call your service
			representative for assistance.
TSI CPLD	The Complex Programmable Logic	1.	Reset the unit and try again.
Fail	Device serving the Timeslot	2.	Call your service
	Interchanger failed.
			representative for assistance.
TSI Fail	The Timeslot Interchanger failed.

Test Status Messages

The Test Status messages in the following table appear in the right column of the System and Test Status screen.

Table 7-3. Test Status Messages

Test Status Message	Meaning
511 Test Active, Pt n	A 511 Test and Monitor is active on the DSL Port n network
	interface.
DLB Test Active, Pt n	A Data Terminal Loopback test is active on Port n.
Lamp Test Active	The Lamp Test is active, causing the LEDs on the front panel to
	light.
LLB Test Active, Pt n	A network Line Loopback test is active on Port n.
No Test Active	No tests are currently running.
Remote LLB Dn	A Remote Line Loopback Down command is being sent.
Active, Pt n
Remote LLB Up	A Remote Line Loopback Up command is being sent.
Active, Pt n
RLB Test Active, Pt n	A network Repeater Loopback test is active on Port n.
Telco LLB Active, Pt n	A Telco-initiated Line Loopback is active on the specified
	DSX-1 port.
Telco PLB Active, Pt n	A Telco-initiated Payload Loopback is active on the specified
	DSX-1 port.

8700-A2-GB20-00 April 2000 7-7