Paradyne 8779, 8747, 8777, Hotwire M/SDSL and HDSL2 Termination Units manual Snmp Traps Options

Configuration Options

SNMP Traps Options

An SNMP trap can be automatically sent out through the EOC or the Management port to the SNMP manager when the unit detects conditions set by the user. These traps enable the SNMP manager to gauge the state of the network. Refer to Appendix B, Standards Compliance for SNMP Traps, for details of SNMP traps supported by the Hotwire Termination Unit.

To configure the unit for SNMP traps, use the SNMP Traps Options screen to:

HEnable SNMP traps.

HSet the number of SNMP managers that receive SNMP traps from the unit.

HEnter an IP address and network destination for each SNMP manager specified.

HSelect the type of SNMP traps to be sent from the unit.

To access the SNMP Traps Options screen, follow this menu selection sequence:

Main Menu → Configuration → Load Configuration From → Edit →

Management and Communication → SNMP Traps

main/config/management/trap
Slot: 4						Model: 87xx
			SNMP TRAPS OPTIONS
SNMP Traps:		Enable			Number of Trap Managers: 9
NMS 1 IP Address:		135.014.040.001 Clear
NMS 2 IP Address:		135.014.003.027 Clear
NMS 3 IP Address:		135.014.001.008 Clear
NMS 4 IP Address:		135.014.002.024 Clear
NMS 5 IP Address:		204.128.146.035 Clear
NMS 6 IP Address:		135.014.003.028			Clear
NMS 7 IP Address:		135.014.001.009			Clear
NMS 8 IP Address:		135.014.002.025			Clear
NMS 9 IP Address:		204.128.146.036			Clear
				Enterprise Specific Traps:		Disable
General Traps:	Both
Link Traps:	Both			Link Traps Interfaces:		All

–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions, ESC for previous menu	MainMenu Exit
Save

A-30 April 2000 8700-A2-GB20-00