Paradyne 8747, 8777, 8779 manual Logging In to the Hotwire Dslam, Initiating an ATI Session, Login

Using the Asynchronous Terminal Interface

Logging In to the Hotwire DSLAM

You can log in to the Hotwire DSLAM system using either a local

VT100-compatible terminal or a remote Telnet connection.

After you enter your user ID and password, the system displays the Hotwire Chassis Main Menu. See your management card documentation for information about selecting the unit from the card selection screen.

Initiating an ATI Session

The Main Menu screen is displayed on the screen unless a login ID and password is required or the ATI is already in use.

If security is enabled on the Hotwire Termination Unit and you used Telnet to access it directly (you did not log in through the management card), the system prompts you for a login ID and password

Login
Slot:	4	Model: 87xx

LOGIN

Login ID:

Enter Password:

––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––

Ctrl-a to access these functions Exit

If you enter an invalid login ID and password after three attempts, the Telnet session closes or the terminal connection returns to an idle state. Refer to Chapter 6, Security.

If the ATI is already in use, the message connection refused is sent to a terminal attempting Telnet access.

2-2 April 2000 8700-A2-GB20-00