P
Passed, self-test result, 7-6payload rate
EIA-530, A-3
relative to line rate, A-5Peer IP Address, A-4performance statistics, 7-11
DSX-1, 7-13
G.703, 7-15
physical environment requirements, D-1pin assignments
front panel, C-1Telco 50-pin, C-3
PLD Failure, self-test result, 7-7Port Status, A-2,A-6,A-8
PORTS LEDs, switching between DSL and DTE, 7-20power requirements, D-1
Primary Clock Failed, status message, 7-5Primary Clock Source
DSX-1, A-7
G.703, A-9
Primary System Clock Failed, status message, 7-5Primary System Clock Reference, A-16
R
related documents, viii
remote send line loopback, 8-7repeater loopback (RLB), 8-5reset
ATI, 3-7AutoRate, 3-8device, 3-7slot, 3-7
restore access to ATI, 3-7
S
Save Configuration screen, 3-6
saving configuration option changes, 3-6to TFTP server, 9-3
screen function keys, 2-7
screens, for user interface, 2-1– 2-6SDSL Mode, A-11
secondary holdover mode, A-14secondary system clock failure, A-14Secondary System Clock Reference, A-16security, 6-1
self-test, results, 7-6Send and Monitor 511, 8-8
Send Remote Line Loopback, 8-7Set Cross Connect Mode, A-18size of card, D-1
SNMP
enable/disable traps, A-30Enterprise Specific Traps, A-31general management capabilities, 1-4limiting management access, 6-5Link Trap Interfaces, A-31
Link Traps, A-31
NMS IP Address, A-28NMS Security Options, A-28Number of Trap Managers, A-30system entries, 3-2
trap manager IP Address, A-30trap NMS destination, A-30traps, B-1
Traps Options, A-29start-up, ATI, 2-1status, test messages, 7-7system
device name fields, 3-2LEDs, 7-19
System Clock options, A-13System Options
DSL Mode, A-11Telco-Initiated Loopback, A-12Test Duration, A-11
Test Timeout, A-11
T
technical specifications, D-1Telco-initiated
line loopback, 8-11loopback, disabling, A-12payload loopback, 8-12remote line loopback, 8-12
Telnet session access, 6-1access level, A-24
Disconnect Time (Minutes), A-24enable/disable, A-24
inactivity timeout, A-24login required, A-24options, A-23
Session Access Level, A-24terminal port, direct connection, 2-1
