TEST AND ADJUSTMENT
❒Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1/2 minute warm up period before it will detect motion. When first turned on, wait 1 1/2 minutes.
❒Turn the RANGE control to the mid position and the
RANGE | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
10 5 1 TEST
MIN MAX
Bottom of Sensor
Avoid aiming the control at:
•Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.
•Areas where pets or traffic may trigger the control.
•Nearby large,
8 ft. | 150° |
| |
(2.4 m) |
|
70 ft. |
|
(21 m) |
|
Maximum Range | Maximum |
| Coverage Angle |
The detector is most sensitive to motion across its field of view.
❒ Loosen the clamp screw in | Clamp | |
the sensor ball joint and gen- | ||
Screw | ||
tly rotate the sensor. | ||
| ||
❒ Walk through the coverage | Ball | |
area noting where you are | ||
Joint | ||
when the lights turn on (also, | ||
| ||
the LED will flash several times |
| |
when motion is detected). |
| |
Move the sensor head up, |
| |
down, or sideways to change | Aim Sensor | |
the coverage area. Keep the | Down for Short | |
sensor at least 1" (2.5 cm) | Coverage | |
away from the lamps. |
|
❒Adjust the RANGE as needed.
RANGE set too high may increase false triggering.
❒ Secure the sensor head by tightening the clamp screw. Do not overtighten the screw.
❒Set the amount of TIME you want the lights to stay on after motion is detected (1, 5, or 10 minutes).
Warning - Risk of fire. Do not aim the lamps at a combustible surface within 3 ft. (1 m).
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 70 ft. (21 m) [varies with surrounding temperature].
Sensing Angle . . . . . . Up to 150°
Electrical Load . . . . . . Up to 300 Watt Maximum In- candescent [Up to 150 Watt maximum each lamp holder.]
Power Requirements . 120 VAC, 60 Hz
Operating Modes . . . . TEST, AUTO and MANUAL
MODE
Time Delay . . . . . . . . 1 , 5, 10 minutes
DESA Specialty Products™ reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.
Motion
Motion
Sensor
Least Sensitive | Most Sensitive |
3 |