Huawei WDR814G, WDR814IG user manual Client Side Computers, Cannot access my ISP’s home page, why?

Page 54

Aolynk WDR814(I)g ADSL2+ Wireless Router User Manual

6 Troubleshooting

menu and follow the instruction as above.

Ensure that your PC and the ADSL Wireless Router are on the same network segment. If you are not sure, initiate the DHCP function and set you PC to obtain an IP address automatically.

Ensure that your PC is using an IP Address within the range 192.168.1.2 to 192.168.1.254 and thus compatible with the ADSL Wireless Router default IP address of 192.168.1.1

Finally, use the Ping command in MS-DOS mode to verify the network connection: Ping 127.0.0.1 to check the TCP/IP stack of your computer

Ping gateway IP (Default: 192.168.1.1) to check the internal link of network.

Note if you’re not able to view the web configuration screen for the ADSL Wireless Router, make sure that you remove any proxy setting within your Internet browser, or remove the dial-up settings within your browser.

Q:What can I do if I have forgotten the password for the ADSL Wireless Router?

You have to reset the Wireless Security Router back to the factory default setting by pushing the Reset button for longer than 5 seconds. Refer to the user’s manual to re-configure the settings.

Q: I cannot access my ISP’s home page, why?

Some ISPs, such as @Home, require that their host name be specifically configured into your computer before you can surf their local web pages. If you are unable to access your ISP’s home page, enter your ISP’s Domain Name into the OnePage Setup (3-3) to enable all computers in your LAN to have access to it. If you only want to allow specific computers to access these home pages, open the TCP/IP Properties window (2-4) on these computers, click the “DNS Configuration” tab and enter your ISP’s Domain Name in the “Domain Name Search Suffix” location.

Client Side (Computers)

Q: I can’t browse the Internet via the ADSL Wireless Router

Check the following:

nCheckthat the LAN Link/ACT LED on the front panel is lit to indicate proper connection between the computer and the ADSL Wireless Router.

nCheckif both ends of the network cable are properly connected.

nCheckthat TCP/IP is installed on your computer (2-4).

For Windows 95/98, use an MS-Dos prompt to run “winipcfg” (“Ipconfig” for Windows NT). Check that the computer’s IP Address is within the range of 192.168.1.2 ~ 192.168.1.254 and the Subnet Mask is 255.255.255.0. If you are using a fixed IP address, also check the Default Gateway IP Address and DNS address in “More”.

nCheckthat the values as stated above are the same in Status Monitor (4-7).

Q: I get a time out error when I enter a URL or IP address.

Check whether other computers work. If they do, ensure the computer’s IP settings are correct (IP Address, Subnet Mask, Gateway IP Address and DNS) (3-3). Then check whether the ADSL Wireless Router’s settings are correct (3-3).

51

Image 54
Contents Huawei BOM All Rights Reserved Trademarks Contents Management GlossaryAbout this Manual Related ManualsOrganization Intended Audience ConventionsEnvironmental Protection Mouse OperationPreface About the Adsl Wireless Router IntroductionContents of the Adsl Wireless Router Package Features of the Adsl Wireless Router Hardware Installation & Setup Rear Panel & ConnectionsFront Panel LEDs OFFSystem Requirements and Setup Pots SplitterInstalling the TCP/IP Protocol Select the Configuration tab Important NoteHardware Installation & Setup Hardware Installation & Setup Fixed IP Addresses Configuration Hardware Installation & Setup Installing the USB driver Hardware Installation & Setup Hardware Installation & Setup Hardware Installation & Setup Internet Access Prepare your networkWeb-based User Interface ISPQuick Start this Adsl Wireless Router WAN Setup Internet Connection SetupGateway Internet IPAddress Subnet Mask Domain NameConnect Name PasswordUser DemandBridged mode Ddns Setup NTP Setup LAN Setup LAN IP setting & Dhcp settingRouting Setting Internet Access Wireless Setup Advanced Wireless Setting Beacon SettingWEP Key IntervalInternet Access Access Policy Advanced ApplicationsSecurity Firewall URLWeb Filter ServicesVirtual Server BlockAdvanced Applications Forwarding Application Protocol Port RangeEnable Enable Check to make this trigger setting activeTrigger DMZ Host Management Settings ManagementManagement LogRemote FunctionDiagnostic-Ping Upgrade Firmware Managemen Troubleshooting HardwareCannot access my ISP’s home page, why? Client Side ComputersFAQ Can Internet users access LAN computers? Technical Specifications Dimension PowerMounting Glossary 10Base-T / 100Base-TDhcp ISP PPP WEP